A guide on building autonomous communication networks with LoRa that work without wider communications infrastructure. Combining techniques for resistance, resilience, and persistence.
Love this article! I'm very new to this stuff and wanted to start building a mesh network in my area so I got a T3 and the battery you linked but for those that are also new I would make sure to look for a battery with JST 1.25mm connector and not a 2.mm because that's what the T3 uses. Made this mistake myself so hope this is helpful to someone else!
This is an incredible, incredible guide. For anyone following with a t3s3, i had to press the “boot” button on the flat side of the chip while turning it on to flash the firmware.
I love this and am working on setting up my own devices.
For the T3, LilyGo only seemed to offer a T3S3, not sure if that's any different than what you used. But that 3d case doesn't fit for the T3S3 devices I've got. Did you have to modify yours or anything?
This is epic work! I am keeping this bookmarked for when we start connecting Regenerative Neighborhoods in my BioRegion!
I was going to tag you and I then I saw you're already here
Yesss! We're very much on the same page about OpenSource alternative communities!
Thank you very much for the detailed guide! So excited to be setting up some more mesh networks throughout Texas!
Love this article! I'm very new to this stuff and wanted to start building a mesh network in my area so I got a T3 and the battery you linked but for those that are also new I would make sure to look for a battery with JST 1.25mm connector and not a 2.mm because that's what the T3 uses. Made this mistake myself so hope this is helpful to someone else!
I would gladly pay for a PDF version of this. I really appreciate all the knowledge and work you put into this.
Putting essential “ how tos” out there for essential equipment is a good thing to do. Thank you!
This is an incredible, incredible guide. For anyone following with a t3s3, i had to press the “boot” button on the flat side of the chip while turning it on to flash the firmware.
I love this and am working on setting up my own devices.
For the T3, LilyGo only seemed to offer a T3S3, not sure if that's any different than what you used. But that 3d case doesn't fit for the T3S3 devices I've got. Did you have to modify yours or anything?